Amplifier Fitting

Recoil 2 Channel 80W adjustable high-to-low level subwoofer amplifier Line Output Converter (LOC) with a built-in amplifier remote trigger. This device is designed to convert 2 channels of speaker level audio into 2 channels of line level audio that can be used by car audio amplifiers.This inter..

Amplifier bypass cable for Land Rover Range Rover L322 (Vogue) cars that have an original DSP amplifier and high line original head unit. This cable extends from the dashboard to the amplifier in the rear and bypasses the amplifier to allow a new stereo to work with the original speakers in the car...

IW-BMW-IMP2.1 Harness CableThe BMW 2.1 IMP HARNESS connection cables are designed for connecting BMW speaker drivers and the IMPULSE 4.320 compact 4-channel digital amplifier. The specific BMW connectors make installation simple.This cable enables amplification of a vehicle's front ..

RBC-1 Remote Bass ControlRemote Bass Control for Select JL Audio AmplifiersThe RBC-1 Remotely Controls the Bass Level of the Following JL Audio Amplifiers:JD-Series: JD250/1, JD500/1, JD1000/1 JX-Series: JX250/1, JX250/1D, JX500/1, JX500/1D, JX1000/1D HX-Series: HX300/1 in Low Pas..

MOST Fibre optic interface to allow the fitting of a new head unit into a  Mercedes ML, GL & R series and retain the use of the fibre optic amplifier. You will lose front to rear fading ability. Also works on some Porsche carsOn Porsche Only for vehicles with the CDR23 CDR24  PCM..

Audio interface with 4 channel adjustable line out put for connecting cars with OEM amplifiers to the ISO connectors of an aftermarket car radio.For cars fitted with original Clarion head-units with pink 10 pin ISO pre-amp socket at the back of the radio.This lead has  a 10 pin connecto..

This adapter allows an aftermarket head unit to be installed, whilst bypassing the factory fitted amplified system. This adapter is designed to match the correct impedance of the vehicles speaker system.When connected your new stereo may not power up, and this is no fault of the wiring harness..

IW IMP 2.2 ISO Cable HarnessThe Focal Inside IW IMP 2.2 car radio car radio adaptation cable is designed for the IMPULSE 4.320 compact 4-channel digital amplifier. It allows the IMPULSE 4.320 to be easily connected to two front channels and two ISUB Twin subwoofers without changing the ori..

5 Channel Line Out Converter With AccubassAudioControl brings you our most advanced line of LOCs yet. OEM integration has never been easier with the host of intelligent built-in features like LMC™ (Load Matching Circuit), allowing even the most finicky factory sound systems to no longer be..

ISO Harness CableThe Focal Inside IW IMP 2.1 car radio adapter cable is designed for the IMPULSE 4.320 four-channel digital amplifier. Without modifying the original wiring,it allows easy connection of the two-channel front amplifier and a PSB 200 subwoofer (two bridged channels).Designe..

ISO to ISO Amplifier Integration Interface4 channel adjustable ISO to ISO amplifier interface.Use to install a new radio in a car that has an original fit amplifier that takes a pre amplified audio feed.This interface converts the high level audio output of a new head unit to a low level..

AudioControl LC8i BlackExperience audio excellence from your existing factory audio system with the AudioControl LC8i 8-Channel Line Output Converter. This powerful converter is the ultimate solution for upgrading your car's audio system. It features channel summing for an immersive audio ex..

Recoil MLOC4MLOC4 4-Channel Smart Micro Line Output Converter with 10V Output and 12V Remote Turn-On Trigger and 60 Ohm Load ImpedanceThe World’s smallest 4-channelmicro speaker cable to RCA line output converter. Use MLOC4 when adding an amplifier to a factory radio to convert the ..

Recoil MGLISuper Mini 2-Channel RCA Stereo Ground Loop Isolator, Made from HIFI Permalloy Transformers, Designed for Audio Signals, Eliminate NoiseEliminates ground loop noise between the audio source and radio. For use with portable devices that have RCA audio outputs, including pre-amp ..

Recoil MALOC2Miniature 2-channel micro adjustable speaker cable to RCA line output converter. Use MALOC2 when adding an amplifier to a factory radio to convert the radio’s speaker level output to the low amplifier (RCA) level input Max 80 Watts of input and delivers up to 10 volts..

Amplifier bypass cable for Volvo XC60, XC90 cars, Allows you to connect a new aftermarket radio directly to the cars speakers after bypassing the original amplifier.The original amplifier in the car has fibre optic connections from the head unit. When replacing the head unit it will be necessary..

MOST fibre optic interface designed to retain the use of the original fibre optic amplifier in Porsche Boxster or 911 to allow the fitting of an aftermarket radio upgrade.The interface connects at the back of the radio, it takes the phono audio output from the new radio and converts it to a digi..

D2B fibre optic interface designed to retain the use of the original fibre optic audio amplifier (Usually Bose systems in cars built between 1998 and 2005) in Mercedes cars to allow the fitting of an aftermarket radio upgrade.Comes with cable to connect power and D2B wakeup to connection for ori..

MOST fibre optic interface designed to retain the use of the original fibre optic audio amplifier (Mercedes Audio Gateway or harman/kardon amplifier) in Mercedes CL, CLS, E Class, SL and SLK cars to allow the fitting of an aftermarket radio upgrade.The interface connects at the back of the radio..

Amplifier bypass cable for Mercedes E Class W211 cars with original COMAND navigation systems. This cable extends from the dashboard to the amplifier in the rear of the vehicle and bypasses the amplifier to allow a new stereo to work with the original speakers in the car. A Fakra to DIN antenna ad..