JBL Club 602CTP

6-1/2" (160mm) Two-Way Component Speaker System with Tweeter Pod

Features

Plus One Woofer Cone Architecture

Plus One Cones Provides more overall speaker one area than other speakers for the same size resulting in higher sensitivity, increased low frequency output and greater musical character

Adjustable Tweeter Output Level

The Club 622 and Club 602C, Club 602CTP Component System Offer a Tweeter Output Level control of 0dB or +3dB to optimise system linearity on installation location

Acoustically damped, UV-resistance Polypropylene cone

Every Club Speakers Woofer Cone is designed to deliver clean, non resonant sound quality, while standing up to the demanding heat and humidity of the car enviormet.

Bigger Magnet, Bigger Power Handling

The new Club lineup features a large magnet delivering higher power handling than competitors at similar price points

Special Tweeter Pod Design for Acoustic Adjustment on Different Listening Position

The Club 602CTP Component speaker system not only including the starfish tweeter mounting adapter and I-Mount Tweeter Mounting kit but also offering the new installation possibility tweeter pod. it is easy to install more importantly the tweeter pod can adjust the angle by up and down even after mounting, which allow you to control the acoustic performance on different listening position.

I-Mount Tweeter Mounting Kit

The I-Mount (Patent no. 5,859,917) tweeter mounting system allows easy and versatile installation of tweeters in each of the component system. it includes flush cup and surface mount mounting hardware.with a 1-3/4” cutout and a 1” mounting depth, installation become a snap. this allows the tweeter to be flush mounted and can be angled up to 40 degrees. Locknuts are included to keep everything in place, and the tweeter can be replaced without removing the whole assembly.

Specifications

• Power Handling  70W RMS, 210W peak
• Sensitivity (@ 2.83V/m) 92dB
• Frequency Response 55Hz – 20kHz
• Nominal Impedance 3.0 ohms

Whats In The Box

• 2 x Speakers
• 2 x Grilles
• 2 x Plastic multi-hole adapter rings
• 1 x Foam gasket
• 2 x Crossovers
• 2 x Tweeters
• 2 x Flush-mount cups
• 2 x Threaded flush-mount adapters
• 2 x Surface-mount cups
• 2 x Starfish tweeter mounts
• 2x Plastics locking nuts
• 36x Screws
• 8 x Speed clips
• 4x Spacers
• 2 x Washers
• 2XTweeter pods
• 2x3M foam